Mitsubishi Programmable Controllers FX-232ADP Manual de instrucciones descargar pdf (Pagina 24)

Single Axis Positioning Modules

Also known as the pulse generator, the FX2N-1PG module creates a pulse train

output that can be used for motion control applications. This module will accept

24VDC inputs. This module can put out a pulse train at speeds

up to 100KHz. The FX2N-1PG attaches to the right side

expansion bus.

The FX2N-10PG module allows for 5VDC or 24VDC inputs. It

offers a maximum output speed of 1MHz. This module also

connects to the right side expansion bus.

The characteristics of the pulse train, such as frequency, and its

OFF/ON status can be controlled by the PLC program or by the

programmer setting parameters prior to operation.

FX3U SSCNETIII Motion Control Module

The FX3U-20SSC-H module provides high-end motion

control capabilities to the FX3U series PLCs. It is

designed to use the MR-J3-B servo line and its’ fiber-

optic SSCNETIII motion network. Amplifiers can be up

to 50 meters away from the PLC via the fiber optic

cables. This module will control up to 2 axes of

motion, with linear and circular interpolation. This

module connects to the right side expansion bus.

FX3U Adapter Bus High Speed Counter Module

The FX3U-4HSX-ADP module connects to the FX3U’s left

side expansion bus, and provides high speed counting ability,

up to 200kHz. The FX3U-4HSX-ADP module does not

require TO/FROM instructions. All data transmissions to and

from this module are directly into the PLC’s memory. A

maximum of 2 high-speed counter modules can be used on

an FX3U CPU. These modules must be located directly next

to the CPU on the left hand side.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 127 128

Sin comentarios

Mitsubishi Programmable Controllers FX-232ADP Manual de instrucciones Pagina 24